When you had your pool settled, the people who did it probable used either concrete or gunite to make the “shell” of the pool.
The problem with both of those materials is that they’re porous so, overtime your pool will leak. This is why plastering is so important, besides makes the pool´s surfaces look and feel nice.
When building a swimming pool, installers most add a ½ inch-thick layer of plaster in the pool’s interior surface.
The problem with plaster is that it doesn’t last forever, actually, the pool’s interior surface typically wears out the fastest depending upon the surface material. Also depending on how much you use your pool and how well you clean and maintain it. pool plaster can endure viable for anywhere from seven to twenty years
So when’s the right time to replastering my pool?
When pools look and feel a bit rough, it’s perhaps time to replastering. If you aren’t sure what this means, you are not the only one. A lot of pool owner’s unknown it.

Replastering a pool means putting a new layer of plaster on the walls and bottom.
Whether you consider it a DYS project or the other way around, you are looking for a pool maintenance and reconstruction Company in Florida, it is important for pool owners to know what the process of replastering their pools involves:
- Get the Pool Prepped
The first step of pool replastering process is turning off any pool equipment, immediately following drain the pool. After that use the sump pump to get out any remaining water, following this, remove any loose debris like leaves, chisel away any plaster that has gotten loose, and then sand down any edges that are sharp or rough. Finally use the cleaning solution and a sponge to clear away any dirt that remains.
- Start the Pre-Plastering Process
First of all, make sure that before you start, you have all the necessary supplements such as protective gloves and eyewear, closed-toe shoes, long-sleeved pants and shirt.
After you suit up in your protective outfit, take your acid brush and spread the acid wash over the old plaster. Secondly use a hose to rinse the acid wash off. Make sure you are thorough.
when the pool surface has completely dried out, apply a bond coat. We most let the bond coat dry. This will take anywhere from 8 to 10 hours.
- Prepare and Apply Plaster

Read all the manufacturer’s instructions on the pool finishes you got and follow all its indications according to the size of your pool and mix the plaster accordingly.
Starting at the deep end of the pool, use your trowel to apply a layer of plaster at least ⅜ of an inch thick. Make sure that the layer is smooth and that you fill in all cracks and holes.
Allow the plaster to dry. Afterward apply a second layer of plaster with the trowel that is about ¼ inch thick. Besides do a double-check to make sure that the surface is as smooth as possible. Remember, it is a most let the finishing layer of plaster dry.
- Getting the job done
Once the plaster is completely dry, add a layer or two of pool paint. As you did for the plaster, allow the paint to dry completely again. Finally, fill up the pool.
Even though this job can be done by yourself, keep in mind that it involves the use of a number of tools you’re likely not very familiar with. So leaving the pool replastering tasks in the expert hands of a pool construction company that you can trust, ensure a job well done quickly, plus a plaster that looks and works as it is supposed to